How to Remove Car Scratches and Make Your Car Scratch Free

How to Remove Car Scratches and Make Your Car Scratch Free

Deep scratches on the car’s surface are clearly visible and really annoying to the owner. Getting each scratch repainted is quite expensive and leaving it would look bad. There are chances that the deep scratches affect the surrounding paint too.

Once the paint starts peeling off, your car looks worse. To avoid this condition, you have two options, either to get the car repainted at a service center or use the products for removing the scratches offered by leading brands. There are different sprays and waxes available for this.

Among a variety of car care products, you can select the one that matches your requirements. Use these products to deliver a new look to your car. If you are wondering about using the products and how to remove car scratches.

Read About How to Remove Car Scratches

Clean the scratch and the area around it using the cleaner. Wash it using a mild soap and water solution, rinse it, and let it dry. There must be no trace of old wax left on the car’s surface. This will prevent the new paint from bonding properly.

While cleaning the traces of old wax, you can use a special car cleaner. Additionally, use 320 grit dry sandpaper and a chemical rust remover for cleaning the surface. Do not rub the surface so hard that the sandpaper scratches the complete paint. Apply it as mentioned on the product.

Now, spray a light coat of primer on the car’s body. Let it dry. Once the first coat settles, add another light coat. Move your hand from one side to another while spraying the car’s surface. Otherwise, the primer will accumulate in one place.

When removing the scratches, the car repair experts prefer several thin layers of coats to repair the car in comparison to one heavy coat. Follow the same procedure when doing on your own. After the paint settles down, you can wax the surface to add gloss to the car’s surface.

Once the spray paint has completely settled down, wipe the surface using a dry cotton cloth. Clean the surface thoroughly to ensure that there is no dust particles left on the surface.

Leave a Reply

Your email address will not be published. Required fields are marked *